Ventilation control sensor with 5-m connection cable
The easy way to operate hard-to-reach ventilators.
Hard-to-reach ventilation units – such as those near the ceiling – can be operated conveniently from the wall using the SIEGENIA ventilation control unit as an external control unit.
Used together with the AEROPLUS WRG wall-mounted ventilator or the AEROMAT VT (except the AEROMAT VT D), it combines easy operation with useful supplementary features which facilitate everyday ventilation. Equipped with sensors, the automatic mode provides demand-based air exchange or activates night cooling.
When necessary, it works in conjunction with automatic mode to automatically regulate the ventilation level required for a healthy indoor environment. Ventilation is particularly precise in the version with sensors, as well as being demand-based. It is equipped with an integrated temperature and humidity sensor, as well as a CO2 sensor. These two sensors allow the control unit to accurately measure the quality of the indoor air at the precise location where it is installed in the room. This enables precise, reliable values to be measured at all times, even with ventilation units whose location will influence the measurement data – such as those close to a radiator, for example.
This product kit contains all the components needed for installing the ventilation control unit for connection to 1 ventilation unit:
It is also possible to purchase an 2 m extension cable if required.
Advantages at a glance.
- Control of up to 9 ventilation units
- Status displayed using LEDs, incl. indication of the air quality using the traffic light system
- Simple wall installation
- No additional power supply required
- Wiring with prefabricated SI bus cable
- Dimensions (W x H x D): 100 mm x 109 mm x 23 mm
Compatible ventilation units.
- AEROPLUS WRG wall-mounted ventilator
- AEROMAT VT facade ventilation system, except AEROMAT VT D variant
Control.
The ventilation control unit follows the master-slave principle. The control unit instructs the master unit in the operating mode and air flow rate. This in turn provides feedback on status, air quality, etc. Up to 8 additional ventilation units can be connected as slave units, which follow the master unit in terms of operating mode and air flow rate.
Power supply and connection.
Power is supplied via the ventilation unit; an additional power source is not required. Pre-assembled SI bus cables in various lengths are available for the connection, which work according to the plug-and-play principle.
This product bundle is supplied with a 5 metre connection cable . An extension cable with a length of 2 metres can also be purchased if required.
Please note that different numbers of connection cables are required depending on the ventilator and the number of ventilators. Therefore, please also take note of our further information regarding the connection on our information page .
