Ventilation control sensor with 1-m connection cable
The easy way to operate hard-to-reach ventilators.
Hard-to-reach ventilation units – such as those near the ceiling – can be operated conveniently from the wall using the SIEGENIA ventilation control unit as an external control unit.
Used together with the AEROPLUS WRG wall-mounted ventilator or the AEROMAT VT (except the AEROMAT VT D), it combines easy operation with useful supplementary features which facilitate everyday ventilation. Equipped with sensors, the automatic mode provides demand-based air exchange or activates night cooling.
When necessary, it works in conjunction with automatic mode to automatically regulate the ventilation level required for a healthy indoor environment. Ventilation is particularly precise in the version with sensors, as well as being demand-based. It is equipped with an integrated temperature and humidity sensor, as well as a CO2 sensor. These two sensors allow the control unit to accurately measure the quality of the indoor air at the precise location where it is installed in the room. This enables precise, reliable values to be measured at all times, even with ventilation units whose location will influence the measurement data – such as those close to a radiator, for example.
This product kit contains all the components needed for installing the ventilation control unit for connection to 1 ventilation unit:
It is also possible to purchase an 2 m extension cable if required.
Benefits at a glance.
- Control of up to 9 ventilation units
- Status displayed using LEDs, incl. indication of the air quality using the traffic light system
- Simple wall installation
- No additional power supply required
- Wired with a prefabricated SI bus cable
- Dimensions (W x H x D): 100 mm x 109 mm x 23 mm
Compatible ventilation units.
- AEROPLUS WRG wall-mounted ventilator
- AEROMAT VT facade ventilation system, except the AEROMAT VT D version
Control.
The ventilation control unit operates using the master-slave principle. The control unit specifies the mode of operation and air throughput for the master unit. The master unit in turn provides feedback on status, air quality, etc. Up to 8 additional ventilation units can be connected as slave units, which use the same mode of operation and air throughput as the master unit.
Power supply and connection.
Power is supplied via the ventilation unit; there is no need for a separate power supply. Prefabricated SI bus cables in various lengths are available for the connection, which operate using the plug-and-play principle.
This product kit is supplied with the 1 m connecting cable . It is also possible to purchase an 2 m extension cable if required.
Please note that the number of connection cables required will vary depending on the ventilator and the number of ventilators. For this reason, please also refer to the additional information regarding connection on our Information page .
